Enviro Cara Manual do Utilizador descarregar pdf (Página 27)

Vent Pipe

Inside Finished Collar

Dry Wall

Wall Thimble

Exterior Wall

Siding

Minimum Vent Terminal 36”

(914mm) High Snorkel Kit.

Figure 46: Installation for Rear Vented;

33,500 Btu/hr.

Place the unit into position.

Attach a small section of pipe on the unit and mark exterior

wall where vent would pass through the wall.

Cut a 10” (25.4 cm) minimum hole in the wall to maintain

clearances to combustibles. Frame hole as shown in Figure

32.

Install a wall thimble, interior nished collar, and the vent

section through the wall.

THIS UNIT MUST BE VENTED WITH A 36” (91 cm) SNORKEL

KIT.

Seal around the vent terminal to the structure using a non-

hardening mastic.

Also refer to

InItIal InstallatIon - Vent ConfIguratIons and

restrICtor settIngs and InItIal InstallatIon - HorIzontal

InstallatIon.

Initial Installation

QUALIFIED INSTALLERS ONLY

conVerting top Vented into rear Vented:

This unit has been shipped as a 33,500 Btu/hr top-vented freestanding unit. This unit can be converted

Figure 45: Converting Top Vented into Rear Vented.

installation of rear Vented appliance:

to a rear vented unit for use with a 36” (915

mm) snorkel. Also refer to InItIal InstallatIon

- InstallatIon of rear Vented applIanCe.

1. Carefully remove the trivet and the

stovetop. Place on a soft surface as not to

damage the nish.

2. Remove the four (4) ¼” screws that hold

the ue collar elbow to the unit body.

3. Carefully remove the elbow being sure not

to damage the gasket that is glued to the

ue collar elbow, it seals the ue to the

rebox (see Figure 42).

4. Turn the elbow 180° to the rear vent

position and re-fasten with the screws

removed in step 2.

Venting

Gasket

Rotate 180

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 45 46

Comentários a estes Manuais

Sem comentários

Enviro Cara Manual do Utilizador Página 27

Comentários a estes Manuais

Manuais e produtos relacionados com Ferramentas Enviro Cara